8-4 TroubleshootingOn-screen error message Action0B60 DIMM group #1 has been disabled Contact your service representative.0B61 DIMM group #2 has been disabled0B62 DIMM group #3 has been disabled0B63 DIMM group #4 has been disabled0B64 DIMM group #5 has been disabled0B65 DIMM group #6 has been disabled0B66 DIMM group #7 has been disabled0B67 DIMM group #8 has been disabled0B70 The error occurred during temperature sensorreadingContact your service representative.0B71 System Temperature out of the range The fan may be faulty, or dusts areclogged in fan.Contact your service representative formaintenance.0B74 The error occurred during voltage sensor reading Contact your service representative.0B75 System Voltage out of the range0B78 The error occurred during fan sensor reading0B7C The error occurred during redundant powermodule confirmation0B80 BMC Memory Test Failed.0B81 BMC Firmware Code Area CRC check failed.0B82 BMC core hardware failure.0B83 BMC IBF or OBF check failed.Power off and reboot the CPU blade. Ifthe error persists, contact your servicerepresentative.0B8A BMC SEL area full. Run SETUP and select [Server] - [EventLog Configuration] - [Clear All Error Logs]to clear error logs.0B8B BMC progress check timeout0B8C BMC command access failed.0B8D Could not redirect the console- BMC Busy -0B8E Could not redirect the console- BMC Error -0B8F Could not redirect the console- BMC Parameter Error -0B90 BMC Platform information Area Corrupted.0B91 BMC update firmware corrupted.Power off and reboot the CPU blade. Ifthe error persists, contact your servicerepresentative.0B92 Internal Use Area of BMC FRU corrupted FRU command and EMP feature areunavailable. This is not a fatal error,however, power-off and reboot the CPUblade. If the error persists, contact yourservice representative.0B93 BMC SDR Repository empty. Power off and reboot the CPU blade. Ifthe error persists, contact your servicerepresentative.0B94 IPMB signal lines do not respond. Access to SMC via IPMB is unavailable.This is not a fatal error, however, power-off and reboot the CPU blade. If the errorpersists, contact your servicerepresentative.
