Installing Windows Server 2003 G-7Create from the menu which appears when running NEC Express5800 Server withNEC EXPRESSBUILDER.If you have only NEC Express5800 Server to create Windows Server 2003 OEM-Disk forEXPRESSBUILDER, use this procedure.If Windows Server 2003 or Windows can be operated on NEC Express5800 Server, you can use theother procedure described later.Follow the steps below.1. Prepare one Flash FDD, or one USB floppy disk drive and 3.5-inch floppy disk.2. Turn on your NEC Express5800 Server.3. Insert the NEC EXPRESSBUILDER DVD-ROM into the optical disk drive of the server.4. Press the RESET switch or press Ctrl, Alt and Delete to reboot the server. (You may alsoturn off and then on again to reboot the server.)The system will boot from the DVD-ROM and NEC EXPRESSBUILDER starts.5. Select [Create the OEM-DISK for Windows] from [Tools Menu] step.6. Connect the Flash FDD or the USB floppy disk drive.(If you use the floppy disk drive, insert a floppy disk into it.)7. Select [Create an Windows Server 2003 OEM-Disk for EXPRESSBUILDER] at [CreateOEM-Disk] and click [Perform].8. Windows Server 2003 OEM-Disk for EXPRESSBUILDER will be created.Write-protect and attach a label, then keep it safely.IMPORTANT:If you have created "OEM-Disk" in the Flash FDD, disconnect theFlash FDD after NEC EXPRESSBUILDER had been shut down.NOTE: If the following message is displayed, the floppy disk iswrite-protected.Cancel write-protected state.If you have already cancelled write-protected state, connect the floppydisk drive again.
