7. Resetting and Clearing the ServerExpress5800/R120f-2E, T120f Maintenance Guide50Chapter 1 MaintenanceThe following instructions show how to clear the CMOS memory and the password.WARNINGBe sure to observe the following precautions to use the server safety. Failure toobserve the precautions may cause death or serious injury. For details, seeSafety Precautions and Regulatory Notices.• Do not disassemble, repair, or alter the server.• Do not remove lithium, NiMH, or Li-ion batteries.• Disconnect the power plug before installing or removing the server.CAUTIONBe sure to observe the following precautions to use the server safely. Failure toobserve the precautions may cause burns, injury, and property damage. Fordetails, see Safety Precautions and Regulatory Notices.• Make sure to complete installation.• Do not get your fingers caught.• Avoid installing under extreme temperature conditions.Important Take anti-static measures before operating the server. For details, see SafetyPrecautions and Regulatory Notices.• Clearing CMOS memory1. Turn off the server, and disconnect the AC power cord from outlet.See Getting Started or Chapter 2 (1. Installing Internal Optional Devices) in User’s Guide to remove TopCover or Side Cover.2. Confirm the position of Clear CMOS Jumper.3. Change the jumper switch from Protect to Clear.4. Wait at least five seconds and then return the jumper switch to Protect.5. Reassemble the server.6. Plug in the power cord and turn on the server.7. POST halts with the following error message.ERROR8006: System configuration data cleared by Jumper.Press to resume, to Setup8. Press key to start BIOS Setup Utility, and then run Load Setup Defaults from Save & Exit menu.
