NEC GT950 User Manual

Also see for GT950 - MultiSync XGA LCD Projector: Specifications Quick connect guide Installation guide

Contents

NEC GT950 User Manual Manual pdf 14 page image

E – 144. LEDFlashes when any button is pressed.5. Power ON ButtonIf the main power is applied, you can use this button to turn your pro-jector on.6. Power OFF ButtonIf the main power is applied, you can use this button to turn your pro-jector off.NOTE: To turn off the projector, press and hold the POWER OFF button for aminimum of two seconds.7. VIDEO ButtonPress this button to select an NTSC, PAL, SECAM or NTSC4.43 com-patible video source from a VCR, DVD player, laser disc player or docu-ment camera.8. S-VIDEO ButtonPress this button to select an S-Video source from a VCR.9. RGB 1 ButtonPress this button to select a video source from computer or compo-nent equipment connected to your RGB port.10. RGB 2 ButtonPress this button to select DVI analog or DVI digital signal from a PCwith DVI output to the DVI-I INPUT connector.The RGB 2 button toggles between DVI analog and DVI digital.11. AUTO ADJ ButtonUse this button to adjust an RGB or DVI (digital/analog) source for anoptimal picture. Some signals may not be displayed correctly or taketime to switch between sources.12. LASER ButtonPress and hold this button to activate the laser pointer. When lit, youcan use the laser to draw your audience's attention to a red dot thatyou can place on any object.13. MENU ButtonDisplays the menu for various settings and adjustments.14. SELECT ( ) (Mouse) ButtonWhen you are in the Computer mode, these buttons work as a com-puter mouse.When you are in the Projector mode, which is indicated by lighting thePJ button:: Use these buttons to select the menu of the item you wish to adjust. : Use these buttons to change the level of a selected menu item.A press of the button executes the selection.When the pointer is displayed, these buttons move the pointer.15. ENTER (Left Click) ButtonWhen you are in the Computer mode, this button works as the mouseleft button.When this button is pressed and held for a minimum of 1.5 seconds,the drag mode is set.When you are in the Projector mode, which is indicated by lighting thePJ button:Use this button to enter your menu selection. It works the same way asthe "Enter" button on the cabinet.16. CANCEL (Right Click) ButtonWhen you are in the Computer mode, this button works as the mouseright button.When you are in the Projector mode, which is indicated by lighting thePJ button:Press this button to exit "Menus". It works the same way as the “Can-cel” button on the cabinet.PJFOCUS ZOOMVOL.SHIFTHELPPOINTERKEYSTONEMAGNIFYFREEZEPIC-MUTEPC CARDSLIDEFOLDERSLIDELISTOFFVIDEOAUTO ADJ.S-VIDEO RGB1 RGB2LASERONPOWERSELECT321Remote Control FeaturesNOTE: If you are using a Macintosh computer, you can click either the right-click or left-click button to activate the mouse.NOTE: If any one of the buttons is pressed and held for 60 seconds or more,the button operations will cease to operate. This is not a malfunction, rather itis a feature used to prolong battery power. To cancel this feature, press any oneof the buttons other than the SELECT button.1. Infrared TransmitterDirect the remote control toward the remote sensor on the projectorcabinet.2. Laser PointerBeams a laser light when "Laser" button is pressed.3. Remote JackConnect your remote control cable here for wired operation.MENUE N TERCANCELPJOFFVIDEOAUTO ADJ.S-VIDEO RGB1 RGB2LASERONSELECTPOWER68711131545910121416