NEC HT1000 User Manual

Also see for HT1000 Series: Control commands Command guide Command guide Control commands Compatibility chart

Contents

NEC HT1000 User Manual Manual pdf 10 page image

E-6Part Names of the ProjectorSELECTCNACELTERNEEMNUSOURCEAUTO ADJUSTON STAND BYSTATUSPOWERLAMP3D REFORMPC-CARDVentilation (outlet)Heated air is exhausted from here* This security slot supports the MicroSaver® Security System. MicroSaver® is a registered trademark of Kensington Microware Inc. The logo istrademarked and owned by Kensington Microware Inc.Built-in Security Slot ( )*Adjustable Tilt Foot Lever (See page E-19)Attaching the lens capTo attach the lens cap to the bottom with the supplied string and rivet:Remote Sensor (See page E-10)Focus Ring (See page E-20)Controls (See page E-7)Ventilation (inlet)Zoom Lever (See page E-20)Carrying HandleLens CapLensAdjustable Tilt Foot (See page E-19)PC CONTROLRGB INDVI-D INSG TRIGGERVIDEO IN S-VIDEO INS-VIDEOS-VIDEORGB/DVIRGB/DVIVIDEOVIDEOAUDIO INAUDIO INCOMPONENTY Cb/Pb Cr/PrStereo Speaker (2W)AC InputConnect the supplied power cable's three-pin plug here, and plug theother end into an active wall outlet. (See page E-17)Main Power SwitchWhen you plug the supplied power cable into an active wall outlet andturn on the Main Power switch, the POWER indicator turns orange andthe projector is in standby mode. (See page E-18)Remote Sensor (See page E-10)PC Card SlotRear FootVentilation (outlet)Heated air is exhausted from hereLamp cover screwRear FootRotate to make the projector level. (See page E-20)PC Card Eject Button1. Thread the string through thehole on the lens cap and thentie a knot in the string.2. Use the rivet to attach thestring to the bottom of theprojector.Iris Lever (See page E-20)Lamp cover (See page E-48)