NEC HT1000 User Manual

Also see for HT1000 Series: Control commands Command guide Command guide Control commands Compatibility chart

Contents

NEC HT1000 User Manual Manual pdf 11 page image

E-79 10 4 5 116 7 8 12 1 32Top Features1. POWER Button (ON / STAND BY) ( )Use this button to turn the power on and off when the main power issupplied and the projector is in standby mode.NOTE: To turn on or off the projector, press and hold this button for a mini-mum of two seconds.2. STATUS IndicatorIf this light blinks red rapidly, it indicates that an error has occurred,the lamp cover is not attached properly or the projector has over-heated. If this light remains orange, it indicates that you have presseda cabinet key while the Control Panel Key Lock is enabled. See theStatus Indicator section on page E-50 for more details.3. POWER IndicatorWhen this indicator is green, the projector is on; when this indicatoris orange, it is in standby or idle mode. See the Power Indicator sec-tion on page E-50 for more details.4. SOURCE ButtonUse this button to select a video source such as a VCR, DVD player,PC or Viewer (PC card).Press and release this button quickly to display the Source List.Each time this button is pressed for a minimum of ONE second theinput source will change as follows:Video → S-Video → Component → RGB → DVI (DIGITAL) → Viewer →Video → ...If no input signal is present, the input will be skipped.5. AUTO ADJUST ButtonUse this button to adjust Position-H/V and Pixel Clock/Phase for anoptimal picture. Some signals may not be displayed correctly or taketime to switch between sources.NOTE: This function may not be available depending upon the input signal.6. PC CARD Access IndicatorLights while accessing a PC card.7. ENTER ButtonExecutes your menu selection and activates items selected from themenu.8. CANCEL ButtonPress this button to exit "Menus". Press this button to return the ad-justments to the last condition while you are in the adjustment orsetting menu.9. SELECT (+) (–) / Volume Buttons : Use these buttons to select the menu of the item you wish toadjust. When no menus appear, these buttons work as a vol-ume control. : Use these buttons to change the level of a selected menu item.A press of the button executes the selection. When the menusor the Viewer tool bar is not displayed, these buttons can beused to select a slide, or to move the cursor in Folder List orSlide List.10. MENU ButtonDisplays the menu.11. LAMP IndicatorIf this light blinks red rapidly, it's warning you that the projection lamphas exceeded 1500 hours (up to 2000 hours in Eco mode) of service.After this light appears, replace the lamp as soon as possible. (Seepage E-48). If this is lit green continually, it indicates that the lampmode is set to Eco. See the Lamp Indicator section on page E-50 formore details.12. 3D REFORM ButtonPress this button to enter 3D Reform mode to correct the keystone(trapezoidal) distortion, and make the image square.