3. Troubleshooting Functional Failures in Operation1233.21 Problems on Power Saving Feature3.21.1 Schedule Is Disabled [IP8800/S6700] [IP8800/S6600]If schedule is disabled, follow the instruction shown below.1. Check to see if the current time is included in the displayed schedule by using the show power-controlschedule command, and isolate the problem according to the table below.Table 3-69: Problems and Actions When Using Power Saving Feature with Power Saving FeatureNo. Display of Result Confirmation Cause Action1 Current time is notincludedCheck to see the setting byconfiguration commandschedule-power-control time-rangeThe setting byconfiguration commandschedule-power-control time-rangeis incorrect.• Specify the time including the currenttime if not.• If an entry including the current time isset to disabled, delete the entry that isset to disabled.2 Current time isincludedCheck to see if the featurespecified by configurationcommandschedule-power-control and the feature specifiedduring normal hours both arenot matched. If it is same, seethe Cause and Action.The features assigned byconfiguration commandschedule-power-control is alreadyoperating.Check to see the setting of theconfiguration commandschedule-power-control.3 Using the show systemcommand, check to see if"changing suspended" appearsin the status of BSU/PSP. If so,see the Cause and Action.The shortage of thenumber of operatingBSUs/PSPs occurs.To control the power of BSU/PSP, makeredundant configuration of BSU/CSU.For information on redundantconfiguration, see the manual"Configuration Settings."4 Using the show loggingcommand, confirm that there isno change on the system timewithin 30 minutes before thestart and end times of theschedule.Schedule error caused bysystem time changeoccurs.Wait for a while because the schedule willstart within 30 minutes. For noticesregarding time change, see the manual"Configuration Settings."
