3. Troubleshooting Functional Failures in Operation303.4.3 Actions against Troubles on 10BASE-T/100BASE-TX/1000BASE-TIf a trouble occurs on 10BASE-T/100BASE-TX/1000BASE-T, follow the procedure below to isolate the problem.1. Checking logFor the log, see the manual "Message Log Reference."2. Isolating the problem according to the failure analysis methodIsolate the problem according to the failure analysis method listed below.5 fault Unavailable configuration has been set. Use configuration command fldm prefer tocorrectly set flow distribution pattern of the filterand QoS function.6 Use configuration command fwdm prefer tocorrectly set the distribution pattern of themaximum number of entries per device.7 The BSU/PSP is faulty. According to the log of the BSU displayed by theshow logging command, see the correspondingpart in manual "Message Log Reference" andfollow [Action] described.8 inactive[IP8800/S6700]The inactivate bsu command is set. Use the activate bsu command to make theBSU active, standby hot, or standby cold status. Ifit does not become standby hot or standby coldstatus, see "3.20 Problems on RedundantConfiguration of Basic Switching Unit (BSU)[IP8800/S6700]."9 The BSU is not fully inserted. Install the BSU board correctly.10 Different type of BSUs are installed together. Unify the type of all BSU boards.11 BSU not supported by the software version isinstalled.Check the BSU board type and software version.Replace the BSU board or update the software.12 BSU not supported by this device is installed. Replace the BSU board.13 notconnect[IP8800/S6700]The BSU is not installed. Check if as many BSU boards as required for activeBSU + standby BSU (if standby BSU is notrequired, only active BSU) are installed. If so, noaction is required. If not so, install the requirednumber of BSU boards.14 initialize The BSU/PSP is being initialized. Wait until initialization completes.15 disable[IP8800/S6700]no power enable is set by configurationcommand.After checking that the BSU board to be used isinstalled, use configuration command powerenable to make the BSU active, standby hot, orstandby cold status. If it does not become standbyhot or standby cold status, see "3.20 Problems onRedundant Configuration of Basic Switching Unit(BSU) [IP8800/S6700]."No. BSU OperationStatusProblem Action
