NEC MULTEOS M40 User Manual

Also see for M40 - MULTEOS - 40" LCD TV: Specifications Specifications User manual Features and benefits Manual

Contents

NEC MULTEOS M40 User Manual Manual pdf 18 page image

English-121. Determine the installation locationCAUTION: Installing your LCD display must be done by aqualified technician. Contact your dealer formore information.CAUTION: MOVING OR INSTALLING THE LCD MONITORMUST BE DONE BY TWO OR MORE PEOPLE.Failure to follow this caution may result in injuryif the LCD monitor falls.CAUTION: Do not mount or operate the display upsidedown, face up, or face down.CAUTION: This LCD has a temperature sensor and coolingfan. If the LCD becomes too hot, the cooling fanwill turn on automatically. If the LCD becomesoverheated while the cooling fan is running, the“Caution” menu will appear. If the “Caution”menu appears, discontinue use and allow theunit to cool. Using the cooling fan will reduce thelikelihood of early circuit failure and may helpreduce image degradation and “ImagePersistance”.If the LCD is used in an enclosed area or if theLCD panel is covered with a protective screen,please check the inside temperature of themonitor by using the “HEAT STATUS” control inthe OSM (see page 27). If the temperature ishigher than the normal operating temperature,please turn the cooling fan to ON within the FANCONTROL menu within the OSM (see page 27).IMPORTANT: Lay the protective sheet, which was wrappedaround the LCD monitor when it waspackaged, beneath the LCD monitor so asnot to scratch the panel.2. Install the remote control batteriesThe remote control is powered by two 1.5V AA batteries.To install or replace batteries:NEC recommends the following battery use:• Place “AA” size batteries matching the (+) and (-) signson each battery to the (+) and (-) signs of the batterycompartment.• Do not mix battery brands.• Do not combine new and old batteries. This can shortenbattery life or cause liquid leakage of batteries.• Remove dead batteries immediately to prevent batteryacid from leaking into the battery compartment.• Do not touch exposed battery acid, it may injure skin.NOTE: If you do not intend to use the Remote Control for along period of time, remove the batteries.3. Connect external equipment(See pages 14-20)• To protect the external equipment; turn off the mainpower before making connections.• Refer to your equipment user manual for furtherinformation.4. Connect the supplied power cord• The equipment should be installed close to an easilyaccessible power outlet.• Please attach power cord to the LCD monitor byattaching the screw and clamp.• Fully insert the prongs into the power outlet socket.A loose connection may cause image degradation.NOTE: Please refer to “Safety Precautions andMaintenance” section of this manual for properselection of AC power cord.SetupScrew ClampScrew hole for clampA. Press and slide to open the cover.B. Align the batteries according to the (+) and (–)indications inside the case.C. Replace the cover.CAUTION: Incorrect usage of batteries can result in leaksor bursting.01_English 18/12/06, 8:52 AM12