NEC MultiSync LCD4020 User Manual

Also see for MultiSync LCD4020: Specifications Specifications Manual User manual User manual

Contents

NEC MultiSync LCD4020 User Manual Manual pdf 32 page image

English-30TV TUNER TUNERTUNING BAND Choose AIR or Cable as TV source.CHECK DTV SIGNAL Shows the status of the Digital TV signal.CHANNEL SEARCH Searches for TV channels and stores them in memory.ADD ON CHANNEL Searches for TV channels and stores them in memory without erasing previously stored channels.SEARCHFINE TUNING Performs fine adjustments to analog channels.CHANNEL EDIT Add or remove channels stored in memory.CHANNEL LABELS Add a label to the channel.CONFIGURATIONMENU LANGUAGETIME ZONEPASSWORD SET Set the Parental Control Password. Factory default password is 0000.PARENTAL CONTROLPARENTAL Parents can choose to block types of programming based on rating and content.CONTROL MENUADVANCED Downloadable rating, depending on broadcast. Press SET to change setting.RATINGCLOSED CAPTION NOTE: Closed captioning settings can not be adjusted for the VIDEO/S-VIDEO inputs.OPTIONS AUTOMATIC is is the only option available for these inputs.RESOLUTION Set the displayed image to the desired resolution.AUDIOAUDIO LANGUAGE Choose the language of audio output.DIGITAL AUDIO Select the digital audio output source. Choose Dolby D/PCM/OFF.OUTPUTNot all modelshave the DigitalTuner installed.* The product you purchased may not have this feature.Connecting to a TV* (For U.S.)Initial TV SetupBefore watching TV for the first time it is necessary toprogram the channels.1. Attach the cable or antenna to the coaxial RF Connectoron the side of the monitor.NOTE: Cable distribution system should be grounded(earthed) in accordance with ANSI/NFPA 70, theNational Electric Code (NEC), in particular section820.93, Grounding of Outer Conductive Shield of aCoaxial Cable.2. Enter the OSD and go to the TUNER menu below.3. In the TUNING BAND menu select which tuning method(Air, Cable, Cable HRC, Cable IRC) will be used.4. Enter the CHANNEL SEARCH menu. Press SET toautomatically scan and store channels to memory.The channel search will store both analog and digitalchannels.NOTE: Analog channels are indicated with a -0 followingthe channel number. Digital channels are indicatedwith a - followed by a number. For example,channel 2-0 is analog and channel 2-1 is digital.Analog channels may also have separate digitalsubchannels associated with them. For examplechannel 3-0 would be analog followed by channel3-1, 3-2, etc.5. Once channels are in memory, use the CHANNEL EDITmenu to add or remove channels. Use the CHANNELLABELS menu to create unique names for channels, ifdesired.Parental Controls (TV, VIDEO input only)Parents can block certain types of programming based onrating and the content.To block programming:1. Enter the PARENTAL CONTROL menu, found under theCONFIGURATION submenu within the TUNER OSD.2. Enter the password. Default password is 0000. Thispassword can be changed in the PASSWORD SETmenu.3. Highlight the square next to the type of programming youwish to block and press SET on the remote.NOTE: Blocking one type of programming willautomatically block all higher rated programmingalso. However, it is possible to unlock thisprogramming while keeping the desiredprogramming blocked.TV TUNER