English-39EnglishOSDLANGUAGE Select the language used by the OSD.ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLSVENSKAРУССКИЙOSD TIME Turns off the OSD after a period of inactivity. The preset choices are 10-240 seconds.OSD POSITION Determines the location where the OSD appears on the screen.UPDOWNRIGHTLEFTINFORMATION OSD Selects whether the Information OSD is displayed or not. The Information OSD will appear when the input signalor input source changes. The Information OSD will also give a warning when no signal is detected or the signal isout of range.An interval between 3 to 10 seconds is selectable for the Information OSD to appear.COMMUNICATIONINFO.The MONITOR ID and IP ADDRESS will appear when the remote control Display button is pressed.OSD TRANSPARENCY Selects the transparency of the OSD.OSD ROTATION Determines the OSD orientation between landscape and portrait.LANDSCAPE Shows the OSD in landscape orientation.PORTRAIT Shows the OSD in portrait orientation.KEY GUIDE Key guide is shown when the OSD menu is displayed.NOTE: This function is not available when OSD FLIP is “ON”.MEMO Defines a title and a message via HTTP server. See page 56.INPUT NAME You can create a name for the INPUT currently being used.Max: 14 characters, including Space, A-Z, 0-9, and some symbols.RESET Resets the following settings within the OSD menu back to factory setting:OSD TIME, OSD POSITION, INFORMATION OSD, OSD TRANSPARENCY.MULTI DISPLAYAUTO TILE MATRIXSETUPTILE MATRIX allows one image to be displayed over multiple screens (up to 100) through a distribution amplifier.Allows auto setting of TILE MATRIX by inputting the number of monitors arranged horizontally and vertically onthe primary monitor. Following settings are set automatically: MONITOR ID, TILE MATRIX, TILE MATRIX MEM,Input Signal, VIDEO OUT SETTING, DisplayPort in TERMINAL SETTINGS.NOTE: AUTO ID will be automatically executed. When you use this function, it is recommended that monitors bechained by DisplayPort cable. This function is released if MOTION in SCREEN SAVER is activated.Example of installation via LAN:H MONITORS 3V MONITORS 3Primary monitorSETTING COPY In a daisy chain scenario, select the OSD menu categories that you want to copy over to the other monitors.NOTE: When you use this function, monitors should be daisy chained by LAN cables. This function will be resetto default when power is off. This function has a limit in the number of connected monitors, depending on typeand quality of the LAN cable you use.COPY START Select “YES” and press the SET button to start copying.ALL INPUT All input terminals settings are copied when you select this item. Default is off.