English-5EnglishFor contents, please refer to the contents sheet.This device cannot be used or installed without the TabletopStand or other mounting accessory for support. For properinstallation it is strongly recommended to use a trained,NEC authorized service person. Failure to follow NECstandard mounting procedures could result in damage to theequipment or injury to the user or installer. Product warrantydoes not cover damage caused by improper installation.Failure to follow these recommendations could result invoiding the warranty.MountingDO NOT mount the monitor yourself. Please ask yoursupplier. For proper installation it is strongly recommended touse a trained, qualified technician. Please inspect the locationwhere the unit is to be mounted. Mounting on wall or ceilingis the customer’s responsibility. Not all walls or ceilings arecapable of supporting the weight of the unit. Product warrantydoes not cover damage caused by improper installation, re-modeling, or natural disasters. Failure to comply with theserecommendations could result in voiding the warranty.DO NOT block ventilated openings with mountingaccessories or other accessories.For NEC Qualified Personnel:To ensure safe installation, use two or more brackets tomount the unit. Mount the unit to at least two points on theinstallation location.Please note the following when mountingon wall or ceiling• NEC recommends mounting interfaces that comply withUL1678 standard in North America.• NEC strongly recommendsusing size M8 screws(15-17 mm + thicknessof bracket and washers inlength). If using screwslonger than 15-17 mm,check the depth of the hole.(Recommended FastenForce: 1125 - 1375 N•cm).Bracket hole should be under 10 mm.• Prior to mounting, inspect the installation location toensure that it is strong enough to support the weight ofthe unit so that the unit will be safe from harm.• For detailed information, refer to the instructions includedwith the mounting equipment.• Make sure that there is no gap between the monitor andthe bracket.• When used in a video wall configuration for a longertime, slight expansion of the monitors may happen due totemperature changes. Due to this it is recommended thatover one millimeter gap is kept between adjacent monitoredges.• When installing, do not apply pressure to the screen orexcessive force to any part of the monitor by pushingor leaning on it. This may cause the monitor to becomedistorted or damaged.To prevent the LCD monitor from falling off from the wall orceiling, NEC strongly recommends using a safety wire.Please install LCD monitor in a spot of the wall or ceilingstrong enough to support the monitor.Prepare the LCD monitor using mounting accessories suchas hook, eyebolt or mounting parts and then secure the LCDmonitor with a wire. The safety wire must not be tight.CAUTION: Do not attempt to hang the monitor using aninstallation safety wire. The monitor must beproperly installed.Please make sure the mounting accessories are strongenough to support the LCD monitor before mounting it.CAUTION: If you use handles for safety wire please refer toHandles for safety wire below.Handles for safety wire: Factory set position.: Alternate position.Solid line: Handle placement for safety wire in landscapeposition.Dotted line: Handle placement for safety wire in portraitposition.V754Q/V864QV984QInstallationScrewUnit15-17 mm Thicknessof bracketand washersunder 10 mmNo gapWashersMountingBracketNo thread4 mm