NEC MultiSync V984Q User Manual

Also see for MultiSync V754Q: User manual Installation guide Setup guide Installation guide User manual

Contents

English-51EnglishConnecting to a NetworkUsing a LAN cable allows you to specify the Network Settings and the Alert Mail Settings by using an HTTP server function.To use a LAN connection you are required to assign an IP address.Example of LAN connection:ServerHubNOTE: Use a category 5 or higher LAN cable.LAN cable(not supplied)Network Setting by Using an HTTP BrowserOverviewConnecting the monitor to a network allows for monitor control from a computer via the network.The IP address and subnet mask of the monitor can be set on the Network Setting screen of the web browser by using an HTTPserver. Please be sure to use “Microsoft Internet Explorer 10” or a higher version for the web browser.(This device uses “JavaScript” and “Cookies” and the browser should be set to accept these functions. The setting method willvary depending on the version of the browser. Please refer to the help files and the other information provided in your software.)Access is gained to the HTTP server function by starting the Web browser on the computer via the network connected to themonitor and entering the following URL as described below:Network Settinghttp:///index.htmlHINT: The default IP address is assigned automatically to the monitor.The exclusive application can be downloaded from our website.NOTE: If the MONITOR NETWORK SETTINGS screen does not appear in the web browser, press the Ctrl+F5 keys torefresh your web browser (or clear the cache).If the monitor appears to be slow in response to commands or clicks on buttons in the browser, or the general speedof operation is unacceptable, this may be due to network traffic or the settings on your network. Should this happen,consult your network administrator.The monitor may not respond if the buttons shown on the browser are repeatedly pressed in rapid intervals. Shouldthis happen, wait a moment and repeat. If you still can’t get a response, turn the monitor off and then back on.To control a monitor please use the control command. See “Control command diagram” (page 57).Controlling the LCD monitor via LAN Control