NEC N8406-022A Reference Manual

Also see for N8406-022A: Application guide

Contents

NEC N8406-022A Reference Manual Manual pdf 25 page image

Browser-based interface 25Boot ManagementOn the BBI, choose System Settings > Boot Management to backup or restore the switch configuration, update theswitch software image, or get dump file.The following table describes the configuration.Table 12 Boot ManagementCommand DescriptionReboot the Module button Reboots the switch.Next boot config block Selects the Configuration Block file (active, backup or factory) that will run afterthe next reboot.Image to boot Selects which software image (image1 or image2) you want to run in switchmemory for the next reboot.Image to transfer Selects a software image to replace with the downloaded software.Current Image InformationImage 1 Displays information about the current Image 1 software. When NormalPanel isdisplayed, the conventional Layer 2 switch software is stored in Image1.Image 2 Displays information about the current Image 2 software. When SmartPanel isdisplayed, the SmartPanel software is stored in Image2.Boot kernel Displays the version number of the current Boot software.Update Image/CfgMethod to use for transfer Select the method to use for transfer (TFTP, FTP or HTTP). HTTP is availableonly for Get Image.Settings for using FTP or TFTP ServerServer Address Enter the IP address of the TFTP or FTP server from which you will transfer thefile.Remote File Name Enter the name of the file on a TFTP or FTP server that contains the file youwant to transfer.ButtonGet Image Starts download of the software image file indicated in Remote File Name fieldfrom the specified TFTP or FTP server.Put Image Starts upload of the software image file indicated in Remote File Name fieldfrom the specified TFTP or FTP server.Get Cfg Downloads a previously saved switch Configuration Block file indicated inRemote File Name from the specified the TFTP or FTP server.The active configuration will be replaced with the commands found in thedownloaded configuration file. The file can contain a full switch configuration ora partial switch configuration.The new configuration is not activated until the apply command is used. If theapply command is found in the configuration script file loaded using thiscommand, the apply action is performed automatically.Put Cfg Uploads the switch’s active configuration to the script configuration filespecified in Remote File Name. The file is placed on the TFTP or FTP server.