Installing and Using Utilities 5-81Refresh of View based on State Change Alert SettingA new function is supported so that NEC ESMPRO Manager window will be updated on a systemstate change basis (in other words, whenever necessary). This function is OFF by default. See the[Setting] below about how to turn it ON.NEC ESMPRO Manager window is updated by one minute-interval polling by default. Therefore,there is some time-lag for NEC ESMPRO Manager to recognize changes in NEC Agent. By usingthis function, the time-lag can be reduced. However, it may consume a little bit more network bandwidth since each state change will be notified to NEC ESMPRO Manager as some kind of alert.[Setting]1. Select [All Programs] → [Esmpro] from the start menu and click [Manager Settings].[Manager Settings] dialog box2. Check [Enable the State Change Alert Setting].3. Click the [Agent Setting...] button.[State Change Alert Setting] dialog box4. Check the name of servers sending the state change alert to the Manager when the Agentrecognizes changes in the state.Click the [Execute] button for the setting change to take effect.5. Refer to “To change the settings of the SNMP Service:” in “Preparation before Setup” inChapter 5 of the User’s Guide (Setup) to configure destinations to send state change alerts.(This server sends state change alerts by SNMP).
