NEC N8800-103F User Manual

Also see for Express5800/320Fc-MR: Setup guide

Contents

NEC N8800-103F User Manual Manual pdf 357 page image

Troubleshooting 7-23Problems with NEC EXPRESSBUILDERWhen the server is not booted from the NEC EXPRESSBUILDER CD-ROM, check the following: Did you set the NEC EXPRESSBUILDER CD-ROM during POST and restart theserver?→ If you do not set the NEC EXPRESSBUILDER CD-ROM during POST andrestart the server, an error message will appear or the OS will boot. Is BIOS configuration correct?→ The boot device order may be specified with the BIOS setup utility of the server.Use the BIOS setup utility to change the boot device order to boot the systemfrom the DVD-ROM drive first. [Boot]>When an error occurs while the NEC EXPRESSBUILDER is in progress, the following messageappears. After this message appears, check the error and take the appropriate corrective actionaccording to the error codes listed in the table below.Message Cause and RemedyThis machine is not supported. This EXPRESSBUILDER version cannotbe used for this server. Execute the NECEXPRESSBUILDER on the compliantserver.NvRAM access error Cannot access to the nonvolatile memory(NvRAM).Hard disk access error The hard disk is not connected or it isfaulty.Check whether the hard disk is correctlyconnected.The system-specific informationdoes not exist on the baseboard.Please restore the backup data orwrite the data by using [SystemInformation Management] of theOff-line Maintenance Utility. Onlythe authorized personnel areallowed to do this operation.This message is displayed when NECEXPRESSBUILDER cannot find devicespecific information due to the replacementof a motherboard, etc.Maintenance personnel write informationusing offline maintenance utility.