CHAPTER 3 SYSTEM DATA PROGRAMMING– 309 – NWA-008853-001 Rev.3.097ch3005.fmPAGING ACCESS-CCISGeneral DescriptionThis feature provides dial access to paging equipment from an Attendant Console or station, through theCCIS network.ProgrammingDESCRIPTION DATAAssign the Paging Trunk (COT card and DKcard) to the required LEN.NOTE 1: We recommend the setting of COT/DK card number by CM14, when us-ing Series 3200 R6.2 software orlater.NOTE 2: The DK card number must be as-signed to the first LEN (Level 0) andthe third LEN (Level 2) of each LTslot.(1)(2)000-763: LEND000-D254: COT cardE800-E831 : DK CardFor PIM0/1: E800-E807For PIM2/3: E808-E815For PIM4/5: E816-E823For PIM6/7: E824-E831NOTE 3: Circuit No. 3 of E831 is used forbuilt-in External Equipment In-terface on the MP card by settingCM44.Assign the Paging Trunk (COT card and DKcard) to the required LEN.[Series 3200 R6.2 software required]NOTE 1: The DK card number must be as-signed to the 1st LEN (Level 0) andthe third LEN (Level 2) of each LTslot.(1)(2)XX ZZZ (LEN)XX : 00-59: FP No.ZZZ: 000-127: Port No.D000-D254E800-E831 : DK Card No.NONE : No dataFor FP No.00: E800-E807For FP No.01: E808-E815For FP No.02: E816-E823For FP No.03: E824-E831NOTE 2: Circuit No.03 of E831 is used forbuilt-in External Equipment In-terface of MP card by settingCM44.STARTCM10CM14APAGING ACCESS-CCIS
