2159. Appendix❷ Replacing the Color Wheel (included)The projector comes with a color wheel (6-segment White) installed. An additional color wheel (6-segment Color) isincluded with the accessories that come with the box.TIP:You can replace the pre-installed 6-segment White color wheel with the included 6-segment color wheel to create images with morebrilliant colors to match the source.To replace the color wheel, refer to the following guide.CAUTION:Before replacing the color wheel, be sure to turn off the projector, wait until the cooling fans stop, and turn off the mainpower switch. Allow 1 hour before replacing the color wheel.• Do not touch the disk of the color wheel. Doing so may scratch the disk or leave fingerprints, causing the imagequality to degrade.• Do not remove screws except when specified in the following instructions• Heed the following information if you own two or more projectors:When replacing or re-installing the color wheel, the original color wheel preinstalled or supplied as an accessorymust go back to its original projector. Your color wheel and projector color wheel cover are given an identificationnumber. Be sure to use the color wheel pre-installed or supplied with your projector to match its identificationnumber.If you remove a color wheel from one projector and re-install it into another projector, performance may be com-promised.• Be sure turn off the main power switch before replacing the color wheel. Failure to do so may result in electricalshock or damage to the projector, and cause an irregular color of the projected image.Tool needed: Phillips screwdriver (plus-head)1. Remove the color wheel cover• Loosen the screw on the color wheel cover.• The screw is captive and not removable.(shown from the rear side of the projector)• Slide and remove the color wheel cover.
