453. Convenient Features Storing Changes for Lens Shift, Zoom, and Focus [LENSMEMORY]The adjusted values can be stored in projector memory when using the LENS SHIFT, ZOOM and FOCUS buttons ofthe projector or the remote control. Adjusted values can be applied to the signal you selected. This will eliminate theneed to adjust lens shift, focus, and zoom at the time of source selection. There are two ways to save adjusted valuesfor lens shift, zoom, and focus.Function name Description pageREF. LENS MEMORY Adjusted values common to all the input signals.If no adjusted values are stored in [LENS MEMORY], the values storedin [REF. LENS MEMORY] will be applied for lens adjustment.→ page 123LENS MEMORY Adjusted values for each input signal.Use the adjusted values for the signal with a different aspect ratio orresolution. The adjusted values can be applied at the time of sourceselection.→ page 114NOTE:• PX700W/PX800X: The NP06FL, NP07ZL, NP08ZL, NP09ZL and NP10ZL lenses do not support Zoom position and Focus position.Do not use the LENS MEMORY function to store the lens shift position data when using the NP06FL lens. Doing so may cause ashadow on the screen.• PX750U: Do not use the LENS MEMORY function to store the lens shift position data when using the NP16FL lens. Doing so maycause a shadow on the screen.Zoom position data cannot be stored because the NP16FL lens does not have a zoom function.• Be sure to perform [CALIBRATION] after replacement of the lens.Usage ExampleWhen you wish to display on a screen having a 4:3 aspect ratio an NTSC or other 4:3 aspect ratio signal and anSXGA or other 5:4 aspect ratio signal:Perform shift, focus, and zoom adjustments to set the vertical screen size of the vertically tall 5:4 aspect ratio signalto standard.Both 4:3 aspect ratio signals and 5:4 aspect ratio signals can now be displayed.Note that with these shift, focus, and zoom adjustments, the 4:3 aspect ratio signal will become smaller on thescreen.To eliminate this size reduction, adjust the shift, focus and zoom to the optimum condition for each of the 4:3 aspectratio signal and the 5:4 aspect ratio signal.Memory (storage) of each of these values will permit projection at an optimum condition upon signal switching.To store your adjusted values in [REF. LENS MEMORY]:1. Press the MENU button.The menu will be displayed.
