1095. Using On-Screen MenuNOTE:• When [HIGH ALTITUDE] is selected for [FAN MODE], a symbol icon will be displayed at the bottom of the menu.• It is recommended that you select High speed mode if you use the projector non-stop for consecutive days.• Set [FAN MODE] to [HIGH ALTITUDE] when using the projector at altitudes approximately 5500 feet/1600 meters or higher.• Using the projector at altitudes approximately 5500 feet/1600 meters or higher without setting to [HIGH ALTITUDE] can causethe projector to overheat and the protector could shut down. If this happens, wait a couple minutes and turn on the projector.• Using the projector at altitudes less than approximately 5500 feet/1600 meters and setting to [HIGH ALTITUDE] can cause thelamp to overcool, causing the image to flicker. Switch [FAN MODE] to [AUTO].• Using the projector at altitudes approximately 5500 feet/1600 meters or higher can shorten the life of optical components suchas the lamp.• Your setting will not be affected even when [RESET] is done from the menu.Selecting the Signal Format [SIGNAL SELECT(COMP3)]When an output device is connected to the COMPUTER 3 video input connectors, this sets the input signal.RGB/COMPONENT � RGB and component signals are identified automatically�VIDEO �������������������� This switches to the video signal�NOTE: When a video cable (commercially available) is connected to the COMPUTER 3 video input connectors’ G/Y connector, videosignals can be projected. In this case, set to “VIDEO”.[SEAMLESS SWITCHING]When the input connector is switched, the image displayed before switching is held to switch to the new image withouta break due to absence of a signal.[COLOR SYSTEM]This feature allows you to select the TV video signal, which differs from country to country (NTSC, PAL, etc.).This is set to [AUTO] by factory default. Set this if the projector cannot identify the signal automatically.[DIGITAL AUDIO SELECT]This feature allows you to select the audio inputs for the projector’s HDMI and DisplayPort input connectors.HDMI ��������������������� HDMI: Selects the HDMI input connector’s digital audio�COMPUTER2: Selects the COMPUTER2 audio input connector�DisplayPort ������������ DisplayPort: Selects the DisplayPort input connector’s digital audio�COMPUTER2: Selects the COMPUTER2 audio input connector�Enabling Key Sound and Error Sound [BEEP]This feature turns on or off the button sound or alarm when an error occurs or the following operations are per-formed.- Displaying the main menu- Switching sources- Resetting data by using [RESET]- Pressing POWER ON or POWER OFF button
