1999. Appendix Mounting the cable cover (sold separately)Mounting the separately sold cable cover on the projector allows you hide the cables for a cleanerappearance.CAUTION• After mounting the cable cover, be sure to fasten using the screws provided. If not, the cable cover could fall,damaging the cable cover and possibly resulting in injury.• Do not bundle the power cord and place it under the cable cover. Doing so could lead to fire.• Do not apply excessive force to the cable cover. Doing so could damage the cable cover, resulting in theprojector falling or causing injury.MountingPreparations:1. Connect the power cord and cables to the projector (the connection cords are omitted from the diagrams).2. Prepare a Phillips screwdriver.1. Insert the two round protrusions on the left and right edgesof the cable cover into the grooves in the bottom of theprojector to line it up.NOTE: Be careful not to let the power cord and cables get pinched by thecable cover.2. Turn the cable cover screw clockwise.- Tighten the screw securely.Removing1. Turn the cable cover screw counterclockwise until it turnsloosely.- Hold the cable cover while doing this to prevent it fromfalling.- The screw does not come completely off.2. Remove the cable cover.- Turn the cable cover a little, then lift it off.1212
