Setup and Operation 2-17NOTE: A Supervisor password might be re-quired to select parameters from the IntegratedPeripherals menu.Use the legend keys to make the selections and exit to the Main Menu. Use the followingtable to configure the peripherals:Table Section 2-8 Integrated Peripherals ParametersFeature Options DescriptionCOM1 portCOM2 portDisabledUser-selectablesettingsAutoSelects a unique address and interrupt requestfor the listed COM ports. Auto selects the nextavailable combination.COM1 default: 3F8, IRQ4COM2 default: 2F8, IRQ3COM port settings must match system boardJP9A and JP9B jumper setting, later in thissection.LPT port Disabled378, IRQ 7 (default)User-selectablesettingsAutoSelects a unique address and interrupt requestfor the LPT port. Auto selects the next availablecombination.The LPT port setting must match the systemboard JP9C jumper setting, later in this section.DisketteControllerEnabled (default)DisabledEnables the on-board diskette drive controller.IDE Controller Enabled (default)DisabledEnables the on-board standard IDE controller(secondary channel).VESA IDEcontrollerEnabled (default)DisabledEnables the on-board fast IDE controller (primarychannel).ParityThe Parity option in the Advanced menu controls system memory parity checking. The de-fault setting for the U.S. and Canada is “Disabled.” This parameter might require a Supervi-sor password.NOTE: Due to system specifications requiredby international markets, only international sys-tems support memory parity. Systems sold in theU.S. and Canada do not support memory parity.
