4-8 System Board8. Select the Exit menu with the left or right arrow key. Press Enter to exitsaving changes. Press Enter again to confirm that you want to exit the BIOSSetup utility.9. Power off and unplug the system and any external options. Remove thesystem unit cover.10. Move the jumper to pins 1 and 2 (Normal mode) so the system can restart innormal operation mode.11. Replace the system unit cover. Connect system power cables and externaloptions.12. Power on the system and press F2 to open the BIOS Setup utility beforePOST. Set a new password and re-customize the BIOS settings (seeSection 2).BIOS RecoveryWhile rare, there may be a time when the system BIOS becomes corrupted. If itdoes, it’s usually because a BIOS update was interrupted.To perform a BIOS Recovery, use the following procedure in conjunction with aBIOS Recovery program. The program can be downloaded from the NEC CSDBBS, ftp site, or website. The BIOS Recovery program must be downloaded to adiskette, not to the hard drive. See Section 9 for downloading procedures.1. Power off and unplug the system and any peripherals.! WARNINGThe system power must be off before removing the coverand changing a jumper setting.2. Remove the system unit cover (see “Removing the System Unit Cover”).3. Locate jumper block J6C1 on the system board.4. Remove the jumper from pins 1 and 2 (Normal mode) and store the jumperin a safe place.5. Replace the system unit cover. Connect system power cables and externaloptions.6. Insert the BIOS Recovery diskette in the diskette drive.7. Power up the system and follow the prompts until the recovery is completed.Remove the diskette.8. Unplug and remove system power cables and external options.9. Remove the system unit cover.10. Replace the jumper on pins 1 and 2 (Normal mode).
