System Configuration 2-5System Board Jumper SettingsThe factory settings for Configuration Select jumper block J5G1 on the systemboard are shown in the following table. See Section 4 for procedures to reset thejumper. Specifications for the system board are included in Section 10.System Board Jumper J5G1 SettingsFunction Jumper Pins DescriptionNormalMode1 and 2 Sets the system for normal operation. The BIOS uses thecurrent configuration information and passwords forbooting. Factory setting: pins 1 and 2 jumpered.ConfigureMode2 and 3 Allows system configuration. After POST runs, the Setuputility loads automatically. The Maintenance menu appearsfor setting configuration parameters (including processorspeed and password settings).RecoveryModeNone Enables BIOS recovery procedures. The BIOS attempts torecover the BIOS configuration. A Recovery diskette isrequired (downloadable from the NEC CSD website.Sample Hard Drive Jumper SettingsJumper settings for a some of the hard drives that might typically be found in aPowerMate system appear in the following sections.Maxtor IDE Hard Drive Jumper SettingsThe factory settings for the jumpers on the Maxtor IDE hard drives are shown inthe following table. The settings are for a single drive installed in the system.Specifications for the hard drives are included in Section 10.Maxtor IDE Hard Drive Jumper SettingsFunction Jumper Pins DescriptionMaster Device J50-1 andJ50-2Sets hard drive as master device in single drive system.Factory setting: pins J50-1 and J50-2 jumpered.Slave Device J50-1 andJ50-2Sets hard drive as slave.Cable Select(CSEL)J48-1 andJ48-2Not used. Factory setting: pins J48-1 and J48-2 open.CylinderLimitationJ46-1 andJ46-2Not used. Factory setting: pins J46-1 and J46-2 open.
