3-14 Option InstallationProcessor RemovalRemove the installed processor on the system board as follows.1. Remove the system unit cover as previously described.2. Locate the processor socket (see Figure 3-8).If any expansion boards are obstructing the socket, remove the boards.3. Release the heatsink clip from the tabs on the socket.4. Release the processor by pulling the lever on the socket away from the socket andas far back as it goes without forcing.CAUTION: Before picking up the processor,reduce static discharge by touching the metalframe of the system unit.5. Lift the processor out of the socket.Processor Installation1. Remove the processor currently in the system (described in the previousprocedure).CAUTION: Before picking up the processor,reduce static discharge by touching the metalframe of the system unit.2. Align the notched corner of the processor with the alignment corner in the socketand insert the processor.3. Swing the lever down to lock the processor into the socket.CAUTION: Remember to either reattach theheatsink used with the old processor or install thenew heatsink supplied with the OverDriveprocessor.4. Install the heatsink on the processor and reattach the clip.5. Check to see if the newly installed processor requires a system board jumperchange (see Appendix B, System Board Jumpers).
