iiImportant InformationWARNING TO CALIFORNIA RESIDENTS:Handling the cables supplied with this product will expose you to lead, a chemical known to the State of Californiato cause birth defects or other reproductive harm. WASH HANDS AFTER HANDLING.RF InterferenceWARNINGThis is a Class A product. In a domestic environment this product may cause radio interference in which case theuser may be required to take adequate measures.CAUTION• In order to reduce any interference with radio and television reception use a signal cable with ferrite core attached.Use of signal cables without a ferrite core attached may cause interference with radio and television reception.• This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interferencewhen the equipment is operated in a commercial environment. This equipment generates, uses, and can radi-ate radio frequency energy and, if not installed and used in accordance with the installation manual, may causeharmful interference to radio communications. Operation of this equipment in a residential area is likely to causeharmful interference in which case the user will be required to correct the interference at his own expense.For UK only: In UK, a BS approved power cord with moulded plug has a Black (five Amps) fuse installed for use withthis equipment. If a power cord is not supplied with this equipment please contact your supplier.Important SafeguardsThese safety instructions are to ensure the long life of your projector and to prevent fire and shock. Please read themcarefully and heed all warnings.WARNING• When the projector is damaged, cooling fluids may come out of internal part.Should this happen, immediately turn off the AC supply to the projector and contact your dealer.DO NOT touch and drink the cooling fluid. When the cooling fluids are swallowed or contacted with youreyes, please consult medical attention immediately. If you touch the cooling fluid with your hand, rinseyour hands well under running water.Installation• Do not place the projector in the following conditions:- on an unstable cart, stand, or table.- near water, baths, or damp rooms.- in direct sunlight, near heaters, or heat radiating appliances.- in a dusty, smoky or steamy environment.- on a sheet of paper or cloth, rugs or carpets.• Do not install and store the projector in the below circumstances. Failure to do so may cause of malfunction.- In powerful magnetic fields- In corrosive gas environment- Outdoors• If you wish to have the projector installed on the ceiling:- Do not attempt to install the projector yourself.- The projector must be installed by qualified technicians in order to ensure proper operation and reduce the riskof bodily injury.- In addition, the ceiling must be strong enough to support the projector and the installation must be in accordancewith any local building codes.- Please consult your dealer for more information.
