NEC PlasmaSync 42XC10 User Manual

Also see for PlasmaSync 60XC10: Brochure & specs Supplementary guide Brochure Brochure Brochure

NEC PlasmaSync 42XC10 User Manual Manual pdf 9 page image

English-6Using Optional Stand/MountsAn optional stand or mounting apparatus can be installedeither while the unit is in the upright position or while theunit is face-down.To install the stand while in the upright position, lower themonitor onto to the feet as shown (Figure 1). Use the handlesto support the display while lowering the support holesunderneath the display onto the feet.If stand or mounting apparatus is to be installed while theunit is face-down (Figure 2), be sure to lay the protectivesheet (the foam sheet that the unit was wrapped in)underneath the unit on order to prevent damage to thescreen.This unit must be used with a stand or some type ofmounting apparatus. This unit is not designed for usewithout additional support.For correct Installation and Mounting it isrecommended to use a trained, authorized dealer.Failure to follow correct mounting procedures couldresult in dame to the unit or to the installer.Product warranty does not cover damage caused byimproper installation.CAUTION:To install, follow those instructions included with thestand or mounting apparatus. Use only those devicesrecommended by the manufacturer.Make sure to install stand or mounting apparatus to theunit while on a surface that is strong and stable enoughto support the weight of the unit, such as a floor orsturdy table.Use the specified clasps for installation.Take necessary steps to prevent the unit from tipping orfalling.Mounting LocationThe ceiling and wall must be strong enough to support themonitor and mounting accessories.DO NOT install in locations where a door or gate can hitthe unit.DO NOT install in areas where the unit will be subjectedto strong vibrations and dust.DO NOT install near where the main power supplyenters the building.DO NOT install in where people can easily grab andhang onto the unit or the mounting apparatus.When mounting in an enclosure or in a recessed area, asin a wall, leave at least 2 inches (50mm) of space betweenthe monitor and the wall for proper ventilation (Figure 3).••••••••••••Allow adequate ventilation or provide air conditioningaround the monitor, so that heat can properly dissipateaway from the unit and mounting apparatus.•50mm (2")50mm (2")50mm (2")50mm (2")50mm (2")InstallationFigure 3Figure 1Figure 2TableProtective Sheet