3-38 Options4. Locate the area at the top of the chassis where the hard disk is to be installed (seeFigure Section 3-32).Figure Section 3-32 Installing Optional 3 1/2-Inch Hard Disk Drive5. Hold the hard drive up against the chassis and align the mounting holes in the top ofthe hard drive with the mounting holes in the chassis.6. Secure the hard drive to the chassis with the four screws provided with the hard drivekit.7. Connect a connector on the power cable and a connector on the signal cable to theconnectors on the hard drive. (See the preceding subsection “Minitower5 1/4-Inch Hard Disk Drive Cabling” for cabling instructions.)8. Install the minitower system cover.9. Connect any external peripherals and cables.10. Run the Setup program to set the new configuration (see Section 2).
