NEC SuperScript 150C User Manual

NEC SuperScript 150C User Manual Manual pdf 13 page image

Connecting Your PrinterTo the electrical power supplyYour printer has no ON-OFF switch and is powered assoon as you connect it to the electrical power supply.Before plugging into the power supply socket, makesure that it is on a stable surface, that the top cover isclosed and read the following warning carefully.Make sure the power supplied has the voltage indicatedon the electrical data plate on the base of the printer.If the electrical data plate indicates a different voltage, callyour local retailer immediately. DO NOT, UNDER ANYCIRCUMSTANCES, CONNECT THE PRINTER TO THEELECTRICAL POWER SUPPLY.Make sure that the plug on the power cable of the printeris of the type accepted by the wall socket you intend touse; if it is not, call your local retailer.Do NOT attempt to change the plug yourself.The socket outlet shall be installed near the equipmentand shall be easily accessible.The manufacturer declines all responsibility for accidentsto persons or damage to the printer arising from thenon-observance of this warning.1. Plug the connector end of the power cord into thetwo-pin socket in the rear of the printer.2. Plug the other end of the power cord into a wallsocket.As soon as you plug it into the electrical power supply,your printer will execute a series of internal checks anda mechanical reset. It will be in ON LINE condition (OnLine light indicator lit).After approximately 2 minutes of inactivity, the printerwill go into “standby” mode in which both lightindicators are off and the print head is in its rest positionat the left hand end of its path. To activate it, just send afile to be printed or start any other printer operation.