2-6 Setup and Operation3. Push the battery pack into the bay until the locking latch on the bottom of thesystem clicks into place.How to Recharge the Battery PackWhen battery power gets low, connect your system to the AC adapter and AC power to re-charge the battery pack. Your system is again ready for use and recharges during use. Therecharge time is about the same, if powered on or powered off. (see "Using the ACAdapter.")If AC power is not available, you can replace the battery as follows:1. Place your system in Suspend Mode.2. Remove discharged battery pack and install a charged battery pack (see"Replacing the Battery Pack" for removal instructions).3. Press the Power switch to resume your system.! WARNINGTo prevent accidental battery ignition or explosion, adhere to the following: Keep the battery away from extreme heat. Keep metal objects away from the battery terminals to prevent a shortcircuit. Make sure the battery is properly installed in the battery bay. Read the precautions printed on the battery.Battery HandlingReview the following before handling either an NiMH or an Li-Ion battery. Use batteries only in the computer for which they are designed. Mixing othermanufacturer’s batteries can deteriorate battery and equipment performance. Turn off power to the system after use. Keeping system power on can degradebattery performance and shorten battery life. Clean the battery terminals with a dry cloth if they get dirty. When not in use, store the battery in a cool dry area.SOLD BY laptopia2005 DO NOT RESELL!!SOLD BY laptopia2005 DO NOT RESELL!!
