2-26 Setup and OperationTo end Suspend mode and return to Active mode, press the Power button on thehinge beneath the LCD panel and restart the system.You can set your system to enter Standby or Suspend modes automatically after aspecified number of minutes of system inactivity. System activity includes key-board, VersaGlide, diskette or hard disk drive access, PC Card modem, network,or LAN card, serial, or printer port communications.Power Management SettingsThe system is shipped with many power-saving features already enabled. You can changethe timeout period for these devices in Setup, under the “Power” menu, with the “User Set-ting Battery” and the “User Setting AC” parameters. The following table lists the defaultsettings for “User Setting Battery” operation.Table 2-7 Automatic Power-Saving FeaturesDEVICEDEFAULTTIMEOUT COMMENTVideo Timeout 2 minutes Shuts off video screen after the timeout specifiedelapses.Hard Disk Timeout 15 Seconds Stops the hard disk motor when the hard disk isnot accessed for the specified timeout.CPU Throttle Good Performance CPU “clocks down” to slower speeds.Standby Timeout 2 minutes Specifies when the system enters Standby modeafter total system inactivity.Suspend Timeout 12 Minutes This setting specifies how long the systemremains in Standby mode before enteringSuspend mode.Lid Close Suspend This setting determines what power-saving actionoccurs when the notebook cover is closed whilethe system is on.NOTEIn Windows 95 systems, power man-agement settings under Windows override thesettings established in Setup. Make the Windows95 power saving settings match those in Setupfor the best results.Using Fn-F3Press the Fn-F3 key combination to cycle through LCD only, CRT only, and simultaneousdisplay modes when an external monitor is connected.SOLD BY laptopia2005 DO NOT RESELL!!SOLD BY laptopia2005 DO NOT RESELL!!