Data AssignmentChapter 4INITIAL SETUP 83Procedures for Data Assignment Using CLI1 Log in to a Controller via telnet.Initial settings in the Controller are as follows:IP address:192.168.100.10Subnet mask: 255.255.255.0Assign suitable network settings to PC, and activate Command Prompt. Typetelnet 192.168.100.10 to connect to the WL Controller.The following message appears and asks you to input a user name and apassword. At initial setting, user name (nec) and password (nec) are assigned.Type those ones in the prompt.Note. You must specify PC’s network environment to be in the same subnet with WLController. For example:IP address: 192.168.100.11Subnet mask: 255.255.255.02 Enter Administrative Access Mode.Type enable command to enter Administrative Access Mode. A messageprompt you to enter a password; however, no password is specified at theinitial setting. Type no letter and press the Enter key. The next prompt will bechanged to pound sign (#), indicating you are in Administrative Access Mode.Basic SettingsC:\Documents and Settings\NEC>telnet 192.168.100.10User name:necPassword:Basic SettingsWL111111>enableEnter Password:WL111111#
