Names and Functions of Each Part of WL1700-MSChapter 1OVERVIEW 31LEDsThe following explains LEDs of WL1700-MS.*Active Scan is a function that searches rogue APs through the network.LED Indication StatusCont Status Lamp(Indicates status ofthe controller part)Lights green In normal operationLights red - Hardware is in abnormal state (system start-up is incapable).- System detected an error with its diagnosis function duringpower up.Off Indicated the system is upon activationAP Status Lamp(Indicates status ofthe access pointpart)Lights green Indicates normal operation meets the following conditions:- Access Point part has booted normally- Access Point part is making connection with a WL Controller- One of radios is valid, or radios is invalid but the scanning isactive. (sentry mode)Lights orange Indicates the Access Point part is not attributed to WL ControllerFlashes green andorangealternativelyIndicates the Access Point part is attributed to WL Controller butRadio is in disabled status or Access Point part is booting up5GHz Lamp2.4GHz LampLights green Indicates a client is being associated with radio.Flashes green Indicates a client associated with radio is communicating via theradio.Lights orange Indicates radio and the active scan (*) both are inactive.Flashes orange Indicates a client that is not associated with radio is trying tocommunicate via radio.Flashes green andorangealternativelyIndicates radio cannot transmits signals.- AP is not able to transmit beacon.- Radio is faulty.Lights off Indicates the following:- Radio is not active while active scan (*) is enabled (Sensorymode)- Radio is active, however, client is not yet associated with it.
