Names and Functions of Each Part of SCA-WL10Chapter 1OVERVIEW26Rear ViewNote 1: To prevent AC cord from being removed, secure the AC code with thestopper attached on the WL Controller.Note 2: Redundant configuration can be available by installing two power units.(The figures described in the above are in a single configuration.)LED IndicationThe following explains LEDs of SCA-WL10.LED Indication StatusPWR Lamp Lights green Indicates DC output power is used.Lights off Indicates DC output power is not used.ALM Lamp Lights red Indicates critical alarmLights off Indicates normal operation.ACT Lamp Lights green Indicates normal operationLights off Indicates the system cannot boot (abnormal state).LOAD Lamp Flashes red Indicates accessing to PC card.Ether1 Connector LINK Lights green Indicates a link is active.Flashes green Indicates communicatingLights off Indicates a link is down.100M Lights green Indicates a link is active at 100Mbps.Lights off Indicates a link is active at 10Mbps.Cooling FAN AC Power InletPower SwitchPACTPACT LampStopper for AC Power CablePower UnitNote1Note2
