INSTALLING THE EASYSCAN 2 AFM24Installing the AFM Video Module- Connect the Video Camera cable (Components, 7) to the connector onthe AFM Video Camera (Components, 4) and the Video In connector onthe Controller (figure The easyScan 2 Controller (p.19)).In case of an upgrade, both the scan head and the Controller must be sentin to your local Nanosurf distributor for mounting the Video Camera onthe Scan Head and installing the Video Camera electronics in the Control-ler. After the Controller has been returned, you should install the drivers forthe AFM Video Module (section Installing the drivers for the AFM VideoModule (p.34)).Installing the Signal Module: S- Connect the Break-out cable (Components, 18) to the Signal Out connec-tor on the Controller (figure The easyScan 2 Controller).In case of an upgrade, the Controller must be sent in to your local Nanosurfdistributor for mounting the Signal Module: S electronics in the Controller.Installing the Signal Module: A- Connect one Signal Module cable (Components, 20) to the Signal Outconnector on the Controller and to the Output connector on the SignalModule: A.- Connect the other Signal Module cable to the Signal In connector on theController and to the Input connector on the Signal Module: A.In case of an upgrade, the Controller must be sent in to your local Nanosurfdistributor for mounting the Signal Module: A electronics in the Control-ler.Turning on the Controller- Connect the easyScan 2 Controller (Components, 1) to the mains usingthe mains cable (Components, 3) and turn it on.
