Napoleon BL36NTE-1 Installation And Operation Manual

Also see for BL36NTE-1: Installation manual Owner's manual Owner's manual Installation manual

Contents

Napoleon BL36NTE-1 Installation And Operation Manual Manual pdf 34 page image

W415-1705 / A / 07.13.17EN34electrical information6.5 battery back-up installation• Ensure the gas and electrical power to the appliance is turned off.• Appliance may be hot, do not service until the appliance has cooled.! WARNINGA. Before beginning installation, turn off the gas and disconnect the electrical power supply from theappliance.B. Locate the battery housing supplied in the manual baggie.C. Install four “AA” alkaline batteries (not supplied) into the battery housing, ensure the positive and negativeends correspond with those identified on the holder. (To open the battery housing, slide the back pieceupwards and off of the battery housing).D. Remove the safety screen to easily access the control compartment.E. Attach the wire (on connector) labelled “BATTERY” from the wiring harness, located in the controlcompartment of the appliance, to the battery housing.F. Place the battery housing into the control compartment, ensure that the battery housing is placed in aclean and easily accessible location.G. Reinstall the safety screen. The safety screen must be installed at all times during the appliance operation.H. Turn the gas and electrical power back on to begin operating the appliance.Control moduleBattery housingRed wireBlack wireIn the event of a power failure, your appliance can be operated using the supplied battery back-up.note:Once the power has been restored, remove the batteries from the holder. The system will drain the batteries ifthey are left in the battery holder.note: