Napoleon BL36NTE-1 Installation And Operation Manual

Also see for BL36NTE-1: Installation manual Owner's manual Owner's manual Installation manual

Contents

Napoleon BL36NTE-1 Installation And Operation Manual Manual pdf 50 page image

W415-1705 / A / 07.13.17EN50maintenance24.1! WARNING• This appliance will require maintenance which should be planned on an annual basis.• Service should include cleaning, battery replacement, venting inspection and inspection of the burner,media, and firebox. Refer to the door removal section and remove the door as instructed.• Carefully remove media if necessary (logs, glass, brick panels, etc.).• Using a vacuum with soft brush attachment, gently remove any dirt, debris, or carbon build up from thelogs, fi rebox, and burner. For glass media, follow the installation instructions for pre-cleaning.• Gently remove any build-up on the pilot assembly including thermopile, thermocouple, flame sensor, andigniter (if equipped).• Inspect all accessible gaskets and replace as required.• If equipped with a blower, access the blower and clean using a soft brush and vacuum.• Re-assemble the various components in reverse order.• Inspect the relief system. The appliance relieves through the main glass door or through the fl aps on thefi rebox top. Ensure they open freely, and close sealed.• Check the gas control valve pilot and Hi / Lo knobs move freely, if equipped. Replace if any stiffness inmovement is experienced.• Check for gas leaks on all gas connections up and downstream from the gas valve including pilot tubeconnections.Clean fl ame sensor using a fine emery cloth or a synthetic scrub pad (such as Scotch-Brite™) to remove anyoxides. Clean the pilot assembly using a vacuum with a soft brush attachment. It is important that the pilotassembly is not painted.note:• Annual maintenance should be performed by a qualified service technician• The fi rebox becomes very hot during operation. Let the appliance cool completely or wear heat resistantgloves before conducting service.• Never vacuum hot embers.• Do not paint the pilot assembly38.1! WARNING• Do not use substitute materials.• Glass may be hot. Do not touch glass until cooled.• Care must be taken when removing and disposing of any broken door glass or damaged components. Besure to vacuum up any broken glass from inside appliance before operation.• Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, broken, or scratched.Replacement glass/frame assembly shall be replaced as a complete unit as supplied by the appliancemanufacturer.12.2 annual maintenance12.3 glass / door replacement