Napoleon IR3N-1 Installation And Operating Instructions Manual

Also see for IR3N-1: Installation and operating instructions

Napoleon IR3N-1 Installation And Operating Instructions Manual Manual pdf 13 page image

13W415-1342 / 10.01.14EN4.3 LOG PLACEMENT! WARNINGFAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USEONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTYDAMAGE OR PERSONAL INJURY.LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THEPROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYEDIGNITION MAY OCCUR.THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.76.1AE. Position the right charcoal stripin front of the right middle log, liningup the holes in the bottom with the2 front right studs.F. Position a pin (supplied) into theleft side hole of the rear log, movethe left crossover log into position,lining up the top hole with the pin inthe rear log.C. Place the right middle log intoposition, lining up the two holes inthe bottom with the studs located onthe right side of the burner.D. Position the left charcoal strip infront of the left middle log, lining upthe holes in the bottom with the 2front left studs.PHAZERTM logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that isdifferent in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colourpigments burn in during the heat activated curing process.A. Place the rear log behind the leftand right log supports and ensurethat it's tight to the burner. Make sureto centre the pilot in the notch. Adjustthe log supports tight to the log tohold it in an upright position.B. Place the left middle log intoposition, lining up the two holes inthe bottom with the studs locatedon the left side of the burner.LOG SUPPORTG. Position a pin into the right sidehole of the rear log, move the rightcrossover log into position, liningup the top hole with the pin in therear log.A. Position the left and right logsupport brackets (supplied) onto theburner base. Secure with the screwssupplied. Make sure the bracketsface away from the firebox, asshown.LOG SUPPORT