Napoleon IR3N-1 Installation And Operating Instructions Manual

Also see for IR3N-1: Installation and operating instructions

Napoleon IR3N-1 Installation And Operating Instructions Manual Manual pdf 17 page image

17W415-1342 / 10.01.14EN6.2 OPERATIONIF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULTCAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RUN OUT WITHTHE GLASS DOOR OPENED OR REMOVED.! WARNINGMANTEMPTIMERP1P2FC ampm:LOW BATTERYINDICTORSIGNAL INDICTORTEMPERATUREDISPLAYTIME DISPLAYMODES OFOPERATIONTIMER DISPLAYON/OFFTEMPERATURESETTINGSET BUTTONOFF BUTTONLARGE FLAME BUTTONSMALL FLAME BUTTON6.2.1 GENERAL REMOTE TRANSMITTER LAYOUT6.2.2 PROGRAMMINGA. Press and hold the receiver's reset button until you hear two beeps. (First beep is short, second beepis long.) Release the button after the second beep, refer to "INSTALLATION OVERVIEW" for receiverlocation.B. Within the subsequent 20 seconds press and hold the small flame button on the remote transmitteruntil you hear two additional short beeps confirming the code is set, refer to "GENERAL REMOTETRANSMITTER LAYOUT". (NOTE: One long beep indicates the sequence has failed or wiring isincorrect).NOTE: This is a one time setting only, and is not required after changing the batteries of the remote transmitteror receiver.