Napoleon IR3N-1 Installation And Operating Instructions Manual

Also see for IR3N-1: Installation and operating instructions

Napoleon IR3N-1 Installation And Operating Instructions Manual Manual pdf 19 page image

19W415-1342 / 10.01.14ENA. Using the remote transmitter you may set the flame directly to the "HI" setting by double clicking thelarge flame button . Increasing the flame height can also be done by pressing and holding the largeflame button .B. Using the remote transmitter you may set the flame directly to the "LO" setting by double clicking thesmall flame button . Decrease the flame height can also be done by pressing and holding the smallflame button .NOTE: For fine adjustment tap the large flame button or small flame button when using the remotetransmitter. If the small flame button is held too long the main burner will turn off.NOTE: Time display will flash upon battery installation or when the large and small flame buttons arepressed simultaneously.A. To set the hour press the large flame button .B. To set the minutes press the small flame button .C. Press the "OFF" button to set the time.A. To set the Timer Mode quickly press the SET button, scrolling to the desired mode.B. To scroll through P1 , P1 , P2 ,P2 briefly press the set button.C. Once the desired timer function is shown on the display and the time flashes, press the large flamebutton to adjust the hour and the small flame button to adjust the minutes. Press the "OFF" buttonto set the time.NOTE: The default setting for the Timer Function is as follows: P1 6:00am and P2 8:00pm, P211:50am and P2 11:50pm, refer to "GENERAL REMOTE TRANSMITTER LAYOUT".6.2.8 SETTING THE TIME6.2.9 SETTING THE TIMER FUNCTION6.2.10 FLAME HEIGHTC. To set Nighttime Temperature Mode quickly press the SET button, scrolling to the desired mode, thenhold the SET button untill the "TEMP" on the display flashes.D. To increase the Nighttime Temperature press the large flame button . To decrease the NighttimeTemperature press the small flame button . To use this setting as the new temperature press the OFFbutton.NOTE: When in regular operation the remote will always show the room temperature. Thermostatfunction adjusts the flame height according to the difference between the set temperature and theactual room temperature; as the room temperature gets closer to the set point it will adjust the flamedown.A. Frequent beeping for 3 seconds when the appliance turns on indicates low battery on the remotereceiver. The battery pack is located on the bottom right side of the appliance, refer to "INSTALLATIONOVERVIEW" for location.B. Low battery indicator is in the top right corner of the remote, we also recommend replacing thebatteries every two years.NOTE: When low battery occurs the appliance will shut down. The appliance will shut off if no changehas occurred to the flame height or the appliance has not turned on for a period of 5 days.6.2.7 LOW BATTERY