Napoleon IR3N-1 Installation And Operating Instructions Manual

Also see for IR3N-1: Installation and operating instructions

Napoleon IR3N-1 Installation And Operating Instructions Manual Manual pdf 8 page image

8W415-1342 / 10.01.14EN3.0 INSTALLATION3.1 LEVELLING THE APPLIANCE68.4BClean out ashes from the inside of the wood-burning appliance. Make sure that the chimney and wood-burningappliance are in a clean and sound condition and constructed of non-combustible materials. If necessary haveany repair work done by a qualified person before installing the insert. Remove the existing appliance damperor lock into an open position.Using screws, attach the appliance warning tagto the inside of the firebox of the appliance intowhich the insert is being installed.The sheet-metal parts of the appliance, in whichthe gas appliance insert is to be installed, mustnot be cut.If the wood-burning factory-built appliance hasno gas access hole(s) provided, an access hole of 1½ inch (38.1mm) or less may be drilled through the lowersides or bottom of the appliance in a proper workman like manner. This access hole must be plugged with non-combustible insulation after the gas supply line has been installed.Ensure that existing chimney cleanouts fit properly.The refractory, glass doors, screen rails, screen mesh and log grates may be removed from the existingappliance before installing the gas appliance insert.Smoke shelves, shields and baffles may be removed if attached by mechanical fasteners.The ventilation openings in the existing appliance may be obstructed by the backer plates, aluminium trim etc.but these parts are not to be applied so as to have an airtight seal.! WARNINGRISK OF FIRE, MAINTAIN SPECIFIED AIR SPACE CLEARANCES TO VENT PIPE AND APPLIANCE.W385-0199_BWARNING: THIS FIREPLACE HAS BEEN CONVERTED FOR USE WITH A GAS FIREPLACEINSERT ONLY AND CANNOT BE USED FOR BURNING WOOD OR SOLID FUELS UNLESS ALL ORIGINALPARTS HAVE BEEN REPLACED AND THE FIREPLACE IS RE-APPROVED BY THE AUTHORITY HAVINGJURISDICTION.ATTENTION: CE FOYER A ETE CONVERTI AFIN D’ETRE UTILISE SEULEMENTCOMME FOYER ENCASTRE AU GAZ ET NE PEUT ETRE UTILSE POUR BRULER DU BOIS OUTOUT AUTRE COMBUSTIBLE SOLIDE, SANS QUE TOUTES LES PIECES ORIGINALES AIENTETE REMPLACEES ET QUE LE FOYER SOIT APPROUVE DE NOUVEAU PAR LES AUTORITESAYANT JURIDICTION.ADVERTENCIA: ESTA CHIMENEA SE REMODELÓ PARA USARSE SOLO CON UNAINSERCIÓN DE CHIMENEA A GAS Y NO PUEDE USARSE PARA QUEMAR MADERA NI COMBUSTIBLESSÓLIDOS, A MENOS QUE SE HAYAN REEMPLAZADO TODAS LAS PIEZAS ORIGINALES, Y LA AUTORI-DAD JURISDICCIONAL LA HAYA VUELTO A APROBAR.Move the appliance close to its final position. This appliance is equipped with levelling screws located on thebase. Level using the levelling screws. Levelling the appliance will eliminate rocking or excessive noise whenthe fan is in operation. Once the appliance is level, move it partially into place to allow for all connections to bemade. It is not practical to level the appliance once it has been installed. Determine the required depth prior toinstalling the appliance and adjust the levelling screws accordingly.67.2