When Follow is enabled, the right display and your pads automatically switch to the next 16steps as soon as the playback position reaches the end of the portion currently displayed.10.3.2 Editing Events in Step ModeIn Step mode you can quickly adjust the parameters of events on particular steps.Editing Events in Step Mode on the ControllerYou can adjust the various settings of your events via the left display:1. Press and hold for a second the pad(s) of the step(s) you want to edit. If you want to ad-just the last step you have created, you can skip this step: the last created event is auto-matically selected. You can also use the 4-D encoder or the Page buttons left of the dis-plays to quickly select individual steps.2. Use Knobs 1–4 as described in the table below to edit the position, length, pitch, andvelocity of the selected events:Editing Tool DescriptionKnob 1 (POSITION) Nudges selected events, i.e. shifts selected events on the timelineaccording to the Nudge Grid (the events’ offsets relative to the NudgeGrid are preserved). Hold SHIFT while you turn the knob to temporarilyoverride the Nudge Grid quantization and adjust the positions inextremely small increments. See section ↑10.1.7, Adjusting the StepGrid and the Nudge Grid for more information on the Nudge Grid.If one event only is selected, its position is shown under POSITION. Ifseveral events are selected, the field shows (MULTI).Knob 2 (PITCH) Transposes the selected events by semitones.When only one event is selected, its pitch is shown under PITCH. Ifseveral events are selected, the field shows (MULTI).Working with PatternsRecording Patterns with the Step SequencerMASCHINE - Manual - 457
