Modulation Strip Section Parameter DescriptionMode Selects from the two available behaviors: Standard and Ball (seedescription above).Display Defines how the value is indicated on the strip’s LED chain:Dot: The blue LED indicates the current value. White LEDs aredisabled.Bar: The blue LED indicates the current value. Additionally, whiteLEDs fill the distance between the current value (in blue) and thezero.Ball modeFriction Adjusts the air friction that slows down the ball once you haveremoved your finger. The higher the Friction value, the quickerthe ball will decelerate and stop. When the slider is set fully left,the ball never stops. When fully right, the ball stops instantly.Gravity Adjusts the attraction of your finger on the ball: The higher theGravity value, the faster the ball will move. This parameterdoesn’t affect the ball movement if you throw the ball with yourfinger (see the description of the Ball mode above).Walls Adjusts the behavior of the ball when it reaches the range limits.If Walls is set to On, the ball bounces off the range limit andcontinues its trip in the opposite direction. If Walls is set to Off,the ball jumps to the opposite range limit and continues fromthere in the same direction.14.7 Recording Modulation from Your KeyboardYou can record modulation in MASCHINE from your KOMPLETE KONTROL S-SERIES key-board. To do this, your keyboard must be in Instrument mode.You cannot record modulation when your keyboard is in Scale Edit or Arp Edit mode. Formore information on these modes, see section ↑14.5, Using the Perform Features.KOMPLETE KONTROL IntegrationRecording Modulation from Your KeyboardMASCHINE 2 - Manual - 687
