Stage 1. Running the Installation ScriptChapter 6 Installing Certificate Management System 219Stage 1. Running the Installation ScriptThe setup program extracts files for the Administration Server, Directory Server,Netscape Console, and Certificate Management System and installs the binariesunder the server root directory you have specified. It creates one instance of theAdministration Server, one instance of the Directory Server, and one instance of theCertificate Management System, which is not yet configured. The setup programalso installs Netscape Console and automatically starts the Administration Serverand Directory Server.As you run the initial installation script, the program stores your configurationchoices and generates a initialization file, or installation cache. As installationproceeds, the stored initialization file states information about your choices so far.As a result, you can stop the installation process and restart it as necessary. Yourchoices to the point at which you stopped the installation are automaticallyrestored by the initialization file, and the installation prompts resume at the pointin which you left off.This initialization file applies only to the installation of the Administration Serverand Directory Server. If you want to use the file to do additional “silent”installations, see the documentation for these servers.Running the Installation Script on UNIXTo run the installation script on UNIX, follow these steps:1. Log in as root to install the servers on a UNIX system. This is recommended,but not required. If you are not root, you can install only a local version in adirectory to which you have write access, using ports higher than 1024, forwhich you are the administrator for all services.2. Change to the directory on the distribution CD, and run the setup program.3. Answer the questions that the script asks. You should have previouslycollected the requested information in the section “Information for UNIXInstallation Script” of Chapter 5, “Installation Worksheet.” Most questionshave a default answer shown in square brackets before the prompt. To acceptthe default answer, press Enter at the prompt.Answer the questions for a typical installation as follows:1. Would you like to continue with setup? [Yes]: Press Enter.2. Do you agree to the license terms? [No]: Type yes and press Enter.
