Page 106/112 TECHNICAL SPECIFICATIONS13.5 GEO S12 Analogue TDcontrollers13.5.1 SpecificationsSPECIFICATIONSOutput Section +22 /+16/+10 dBm typ. into 600 Ohm load. Back Panel switch on +6/0/-6dB respectively.Input Section Maximum input Level : 22dBu. CMRR 80dB @ 1kHz typ.THD+N 0.1% @ 1kHz Typ. for +10dBm OutputNoisefloor S12TD -100 dBV for 0dB switch position (22 Hz - 22 kHz, UnWeighted)Dynamic Range 111 dB UnWeighted (THD+N at-60dBr sine wave @1kHz rel.max. output)Crosstalk 104dBFiltering & EQ. L&R: 12dB/oct Low Pass, 12dB/oct High pass (crossover or overlap), 4 Parameter EQs.All factory tunedProtections VCA temp. (SUB,LF & LF), VCEQ disp. (SUB & LF), Peak Limiter (all chanels), Powercompression regulationPower Supply 100-250 Volts (continuous operation), 50/60Hz. Power 9W. Peak Inrush current 0.5A.Earth-Lift.Conformity Comply with safety objective of 73/23/EEC & 89/336/EEC directives. (EN60065-12/2001,EN55103-1996).CB scheme DK-8371, cULus 60065 AZSQ E241312, FCC part15 class BPRODUCT FEATURESAudio Inputs Two differential non floating L&R Audio inputs, 50 kOhm. Two XLR-3F connectors.Sense Inputs Three Amplifier Sense Inputs (S12 L&R, LS). 400 kOhm. 6 Pole Removable StripTerminalAudio Outputs Two L&R S12 Audio outputs. Balanced, non floating, 51 Ohm. Two XLR-3M.One Mono (L+R) LS400 Audio output. Balanced, non floating, 51 Ohm. One XLR-3M.Controls Gain switch (back panel), 3 positions : -6 / 0 /+6dB.Peak Limiter trimmer (1200W-600W/8 Ohms) for S12 & SubbassSub Overlap / Crossover switch & Sub Gain Control (-/+ 6dB).Indicators LF speakers Protect Yellow LED's (Temp. & Disp), Power ON (green), Amp Sense &Peak LED's (green/Red)Dimensions 1U 19" Rack. 165mm (6.5") DepthWeight : 2.9 kg (6.6 lbs) netSYSTEM OPERATIONApplicable Products The S12 TDcontroller is precisely matched to the S12 & associated Subbass and includessophisticated protection systems. Use of either product without a properly connectedController will result in poor sound quality and may damage the components.SubBass Active two-way operation of the S12 Loudspeaker with the associated Subwoofer isincluded in the Analogue S12 TDcontroller .13.5.2 Front and Rear Panel viewBALANCED INPUTSRIGHT LEFTRIGHT LEFTSUB L+ROUPUTLEVEL+6dB0dB-6dBBALANCED OUTPUTSEARTHLIFT115 - 230V 50 - 60Hz 10WCAUTION !To reduce the risk of electric schockgrounding of the center pinof this plug must be maintained.MADE IN FRANCE+ RIGHT - + LEFT -+ SUB -SENSE INPUT(from amp terminals)CAUTION !Sense line must be connectedfor speaker protection.10CEPS8 TDcontrollers.n:031054004
