GEO S12 HARDWARE SETUP PROCEDURE Page 55/1128.4.6 Two GEO S12 flown horizontallyRequired items• 1 x “U” Bracket for two GEO S12s (GEOS12-PSBRK-V2)• 1 x Lifting Ring (GEOS12-XHBRK)• Or 1 x Truss hook (GEOS12-TCBRK-V2)IMPORTANTEnsure that suspension point is strong enough to hold two GEO S12s weight.Procedure• Slide GEOS12-PSBRK-V2 side plates into GEO S12s connecting plate oblong holes;• Lock safety pins into GEO S12s connecting plate;IMPORTANTEnsure that safety pins are properly locked into GEO S12s connecting panels.• Adjust inter-cabinet angle and lock to required angle value with 8x20 quick release pins;• Position “U” bracket over these side plates; align centre holes;• Insert adjustment handles, adjust vertical angle and tight the handles to prevent GEO S12s fromrotating around “U” bracket;Cable suspension:• Connect lifting ring GEOS12-XHBRK to “U” bracket by inserting 8x45 quick release pin dedicatedholes;• Ensure lifting ring is properly locked to “U” bracket;• Connect assembly to suspension point with sling and shackle (not provided).Truss suspension• Connect truss hook GEOS12-TCBRK-V2 to “U” bracket by inserting 8x45 quick release pin indedicated holes;• Ensure truss hook is properly locked to “U” bracket;• Lift and position assembly, lock hook on truss suspension point and secure with hook cable.
