NiceUC NC-AD300E User Manual
                                                                | |
Contents
| 
NC-AD300E Manual- 14 -2.Through Telnet program on the Ethernet.AD300EFTP ServerTelnetConsoleterminalConsoleEhternetBut before use the Telnet,we need to know IP address of the device, and ensure the internetsmoothly.4.1 Terminal connectionWe usually use PC to debugging device,when connecting to device console port,it needs torunning a simulation software on PC, In Windows system, the commonly used "Super Terminal."you can also use any other terminal software, recommended the use of SecureCRT.Use of methods about “Super Terminal” can be found in Appendix II or other materialsWhen use console port,terminal parameter configuration as shown:Baud rate 115200Data bits 8Parity NoneStop bits 1Flow Control NoneNotes: Computer usually have two serial ports,COM1 and COM2,if it’s out withUSB-Serialport, then may be COM3,COM4,COM5 etc.please confirm the choice of the port is correct。。。。It can be use Telnet service through Ethernet connection,in Windows system, point “Start” menuThen choose “Run”,and enter “address of IP” .you can also use other third-party software.such asSecure CRT. Default of the telnet login name is admin ,password is nice.Notes:at the same time ,console port and telnet connection only one,when the telnetConnect ,the Console port will be limited .only when the telnet exit, console portsession can be restored . and through the Ethernet you may connect telnet onlyone,if you have connected a telnet. Re-connect will be limited. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine