NiceUC NC-AD300E User Manual
                                                                | |
Contents
| 
NC-AD300E Manual- 63 -flags (f) : 0x20Attached TCP/IP interface to at0.No link,set speed:100,duplex:FullDuplexNo link,set speed:100,duplex:FullDuplexAttaching network interface lo0... done.Begin to Load pbxe.binAnd then use the "x" command to start device can be.Note: When you upgrade from the boot state, must first set boot parameters correctly.Appendix6.SS7signaling messages introductionACB（Access barred signal）ACC（Automatic congestion control information message）ACM (Address complete message (note)）Note:ACMNote:ACMNote:ACMNote:ACM includingincludingincludingincluding sixsixsixsix kindskindskindskinds ofofofof signalingsignalingsignalingsignalingADC（Address-complete, charge）ADN（Address-complete, no charge）ADX（Address-complete, coin box）AFC（Address-complete, charge subscriber free）AFN（Address-complete, no charge, subscriber free）AFX（Address-complete, coin box, subscriber free）ADI（Address incomplete signal）ANC（Answer signal, charge）ANN（Answer signal, no charge）ANU（Answer signal, unqualified）（Temporarily use）BLA（Blocking-acknowledgement signal）BLO Blocking signal）BSM（Backward set-up message）CBK（Clear-back signal）CCF（Continuity-failure signal）CCL（Calling party clear signal）CCM（Circuit supervision message）CCR（Continuity-check-request signal）CFL（Call-failure signal）CGC（Circuit-group-congestion signal）CHG（Charging message）（Temporarily use）CLF（Clear-forward signal）CNM（Circuit network management message group）COT（Continuity signal）CSM（Call supervision message）DPN（Digital path not provided signal）EUM（Extended unsuccessful backward set-up information message）FAM（Forward address message） |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine