E45Reference Section1 Press the q (Wi-Fi) button on thecamera.• The screen shown on the right is displayed.• If no connection confirmation is receivedfrom the smart device within 3 minutes, themessage No access. is displayed and thecamera returns to the Wi-Fi options screen.• You can also select Connect to smartdevice in the Wi-Fi options menu todisplay the screen shown on the right.2 Set the Wi-Fi setting on the smart device to On.• Check the user’s manual provided with your smart device for further details.• After the network names (SSIDs) that can be used for the smart device aredisplayed, select the SSID displayed on the camera.• When the Auth./encryp. is set to WPA2-PSK-AES in the Wi-Fi optionsmenu, the message for entering a password is displayed.Enter the password that is displayed on the camera.3 Start the “Wireless Mobile Utility” installed on the smartdevice, while Negotiating... Please wait. is displayed onthe camera.• The screen for selecting “Take photos” or “View photos” is displayed.• When the message “Cannot connect to camera.” is displayed, return to step1 and retry the procedure.• See “Installing the Software on the Smart Device” (A60).C When Take photos Is SelectedYou can capture still images using the two methods described below.• Release the shutter on the camera and save the captured images to a smart device.• Use a smart device to remotely release the camera shutter and save images to thesmart device.Connecting to a Smart Device (Wi-Fi)XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXCancelPassword:SSID:Connect to smart device