Nilfisk-Advance SC500 9087352020 Instructions For Use Manual

Nilfisk-Advance SC500 9087352020 Instructions For Use Manual Manual pdf 16 page image

ENGLISH INSTRUCTIONS FOR USE14 SC500 - 909998000011/2014(For machines with EcoFlex™ system)4. Fill the tank (21) with clean water. Use the water removable filler hose (23).Do not fill the tank completely, leave a few inches from the edge. Use the level hose (13) as reference.The water temperature must not exceed 40 °C.Detergent tank filling (For machines with EcoFlex™ system)WARNING!When using floor cleaning detergents, follow the instructions on the labels of the detergent bottles.To handle floor cleaning detergents, wear suitable gloves and protections.5. Lift the cover (34) and check that the recovery tank (33) is empty; if not, empty it using the drain hose (12).6. Close the cover (19).7. Grasp the handle (16) and carefully lift the tank (33).8. Fill the tank (25) with a detergent suitable for the work to be performed (highly concentrated detergent).Do not fill the detergent tank completely, leave a few inches from the edge.CAUTION!Use only low-foam and non-flammable detergents, intended for automatic scrubber applications.NOTETo accelerate filling of the hoses and system operation (with a new system, if the system has been emptied for cleaning,etc.), it is a good idea to drain the EcoFlex™ system once or several times (see the procedure in the Maintenancechapter).MACHINE START AND STOPStarting the machine1. Prepare the machine as shown in the previous paragraph.2. To turn on the machine, insert the operator key (41) in its slot on the control panel (3); if the key is already inserted, press thepush-button (42).3. In the first 2 seconds after machine start-up, the multifunction display (51) indicates the machine working hours (51-A) and thetype of batteries installed (51-B).NOTECheck the battery charge level.When the multifunction display shows at least one segment of the battery symbol (51-C) which is on but not flashing, themachine is ready for use.When the battery symbol (51-C) shows just one segment flashing, the batteries have to be charged (see the procedure inMaintenance chapter).4. Drive the machine to the area it is required by starting it with your hands on the handlebar (1) and pushing the paddle (2)forward to move forward, and backwards to move in reverse. The speed can be adjusted by pressing the paddle (2) more orless. The maximum speed can be set with the push-buttons (46).Stopping the machine5. Stop the machine by releasing the paddle (2).6. Turn off the machine by pressing push-button (42), or by removing the operator key (41) from the control panel (3).NOTEIf the machine is on but not working, it automatically turns off after 2 minutes.7. Make sure that the machine cannot move independently.CAUTION!In the event of an emergency when you must stop all machine functions immediately, disconnect the batteryconnector (9).Reset the machine functions by connecting again the connector.MACHINE OPERATION (SCRUBBING/DRYING)1. Start the machine as shown in the previous paragraph.2. Lower the squeegee (29) with the pedal (8).3. Press the One-Touch™ push-button (43) to lower the brush deck and start scrubbing and drying.4. Start cleaning by manoeuvring the machine and pressing the paddle (2).If necessary, adjust the maximum speed with the push-buttons (46).5. Adjust the solution flow by pressing the push-button (49) as necessary, depending on the type of cleaning to be performed.https://harrissupplyind.com - To Order Parts Call 608-268-8080